What should be noted for silicone products using the dropper process?

With the increasing popularity of silicone products, people's aesthetic standards have risen sharply, and the demand for silicone products has also increased. While ensuring quality, it is also necessary to increase the aesthetic standards for silicone products. Therefore, a new technology - drip glue technology - has emerged. The benefits of drip glue technology for silicone products are not only to protect the surface of the product from wear, but also to pursue high-quality and exquisite appearance of silicone products. It is not difficult to make a lifeless silicone product into a three-dimensional, concave convex appearance effect, and a few points need to be noted.

1. In the process of making dropper silicone products, it is necessary to ensure the cleanliness of all utensils during the dropper process to avoid impurities, ripples, and other defects on the surface after the glue solidifies.

2. In the process of making silicone products using the dropper process, the glue ratio must be accurately weighed, and the glue must be stirred evenly, otherwise it will cause incomplete dropper curing and prolonged curing.

3. The humidity of the glue dispensing working environment should be controlled at 68%. It is not recommended to perform glue dispensing work on rainy days because when the humidity in the air is too high, the mist in the air will directly cause the surface of the glue to oxidize. If the production task is tight, it is recommended to use an air dehumidifier. When producing silicone products with droppings, the silicone products are concentrated in the drying area and the temperature is controlled between 28 ° -40 ° C to ensure that the droppings are of good quality and reduce the defect rate.